ALUMINUM HANDLE FLOGGERS<HAME TIP<AND T HANDLE FLOGGERS

Large size,falls are usually 19-20 inches long.Largest diameter is 1 1/2 inch,after that sizes vary,and handle is cut into a large variety of shapes,and diameters,made in a variety of leathers,and colors.Cowhide,rubber,and suede is usually around $98. Elk,bison,deer,etc.. are higher,depending on the price I pay,usually $115-$139

Medium size,falls are about 18-19 inches long. Largest diameter is 1 1/4 and shaped,and cut down after that. Comes in a variety of leathers,price is between $85-$92 depending on leather.

Small size,falls are around 14-16 inches.Largest diameter is 3/4 in. I have these handles mass produced,and then finish them up,put in holes,polish them,etc...Price is $36-$40 depending on falls,and length.

These handles I buy they are chrome over brass,are heavier than my aluminum  handles,and are found on a horse harness.

Price on these is between $85-$95 make a lot of them in matched pairs,$155-$170

The diameter of these vary,usually around 2-2 1/2 in. in diameter,and about a foot long,falls are 24 inches long. These take a while to make,have a lot of leather in them,price is around $200-$275 depending on leather,size,and hours it takes to make.

I make these in different sizes from 1 1/2 inch diameter to 2 1/2 diameter. I think they are very easy to use especially with a lot of weight and falls,easier on the wrist,and stays in your hand better.Just to warn you some people don't like the irritation it causes between the fingers.1 1/2 size runs between $105-$139. Larger diameters are between $175-$250